Blank Cue screens!!!Help!

Hog 250

I know I'm a "Newbee" but, when I re-load the floppy shows,there always seems to be an issue,.Mostley learning curve.....I think
I now have a decent library (that helps) but when I fire the board up,the LCD's above the cues are "blocks" no #'s or letters,Do I have to re-install software,or another disk? Or is it hardware?(lose connection)
The Manual program mode works,& some of the cues run,but can't be editted......Any thoughts?
Thanks
GF
Parents
  • 0
    Hello again, I tried re-loading the software,it works great for an hour ,sometimes 2-3 hours,then the cue button lights flicker,& the screen eventually blacks out,

    I can get it to re-set eventually by dis-connecting the ribbon cable to the LCD ,power off/on,(some times just by using the off/on switch......) But not what I want to be doing at a show.

    I have e mailed Jands,just a pain to think it may have to go to Austrailia for help......?
    I know it's not your product........still any further thoughts?

    Very dis-heartening...........
    Thanks
    Gfuller2000
Reply
  • 0
    Hello again, I tried re-loading the software,it works great for an hour ,sometimes 2-3 hours,then the cue button lights flicker,& the screen eventually blacks out,

    I can get it to re-set eventually by dis-connecting the ribbon cable to the LCD ,power off/on,(some times just by using the off/on switch......) But not what I want to be doing at a show.

    I have e mailed Jands,just a pain to think it may have to go to Austrailia for help......?
    I know it's not your product........still any further thoughts?

    Very dis-heartening...........
    Thanks
    Gfuller2000
Children
No Data
Related

www.etcconnect.com