hog 2 installation

hi all

I've got whole hog 2 with me
when I boot up it go straight into the 1,clean show 2, old show 3, load new software.

i don't know what happen but now it doesn't boot up normal anymore.

so I've download the latest version and unzip it into 2 diskette

so I attempt to load in a new sotware.
but it kept showing
'Loading....
Disk or program not found'

So I though I might have a bad floppy drive so I change another A Drive.
But still get the same result.

Please help~~~

What are the possibilities for the board to act like this?
I'm pretty sure the diskette are fine since they're new
Parents
  • 0
    [quote=justinpma;39070]Is it possible to change the whole pcb myself?

    Since it appears to run OK otherwise, myself I would look to change the memory chips, at least if they are socketed, first. Or, try swapping them around and see if the problem changes nature . . . . . if so, it would confirm that they are the problem.

    Unless the console has had something spilled into it, or been in very bad environmental conditions, I would think it highly unlikely that anything would have failed in terms of pcb traces . . . . that just doesn't happen typically without mechanical intervention, corrosive substances, etc.

    - Tim
Reply
  • 0
    [quote=justinpma;39070]Is it possible to change the whole pcb myself?

    Since it appears to run OK otherwise, myself I would look to change the memory chips, at least if they are socketed, first. Or, try swapping them around and see if the problem changes nature . . . . . if so, it would confirm that they are the problem.

    Unless the console has had something spilled into it, or been in very bad environmental conditions, I would think it highly unlikely that anything would have failed in terms of pcb traces . . . . that just doesn't happen typically without mechanical intervention, corrosive substances, etc.

    - Tim
Children
No Data
Related

www.etcconnect.com