ETC - Community
Site
Search
User
Site
Search
User
Control Consoles
More
Legacy Consoles
Legacy - Wholehog 2
Pan and then tilt
Home
Forums
More
Cancel
State
Not Answered
Date
channeldave - Former HES Forum Member
Date
Wed, Dec 16 2009 1:34 PM
Replies
3 replies
Subscribers
4 subscribers
Views
236 views
Users
0 members are here
Pan and then tilt
I'm running a show with a Hog 1k. I've noticed that my position fades are kind of weird - they're executing pan and then tilt (or vice versa) instead of at the same time, it looks strange. I think I would have noticed this if it was normal.
my Path is set to "linear"
any ideas?
Parents
0
channeldave - Former HES Forum Member
over 13 years ago
The default path for pan and tilt are set to Linear, and the path of the cue is set to Linear. Is there another way to change it for individual parameters?
The fixtures are the new Chauvet 250w heads. (not my choice, but they're not too bad).
I don't remember it happening before, so maybe I did tweak something.
Cancel
Up
0
Down
Reply
Verify Answer
Cancel
Reply
0
channeldave - Former HES Forum Member
over 13 years ago
The default path for pan and tilt are set to Linear, and the path of the cue is set to Linear. Is there another way to change it for individual parameters?
The fixtures are the new Chauvet 250w heads. (not my choice, but they're not too bad).
I don't remember it happening before, so maybe I did tweak something.
Cancel
Up
0
Down
Reply
Verify Answer
Cancel
Children
No Data
Related