Hog1k to ignite VL2500

Hi,

Always using Macs in the show, but for one day had to use VL2500 spots and washes. We could not make the lamp-on command out of the Hog1000.
In the control channel there is command for that but did not work, we used an avo desk to ignite.
Can someone tell me what is the trick? how can I make it work?

thanks a lot,
Hans

Parents

0 jxgriffi - Former HES Forum Member over 15 years ago

For VL's, you have to have IDLE, then strike for a minimum of 6 seconds and then back to IDLE. Record them into palettes or into a cuelist so they are instant and not going through other commands. Otherwise, while you're scrolling through the control channel, you won't get what you want.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 jxgriffi - Former HES Forum Member over 15 years ago

For VL's, you have to have IDLE, then strike for a minimum of 6 seconds and then back to IDLE. Record them into palettes or into a cuelist so they are instant and not going through other commands. Otherwise, while you're scrolling through the control channel, you won't get what you want.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data