software version 4.0

Have any of you used the console with software version 4.0 beta?
The manual is that version
I would understand if it is stable. If you can use.

in Version 4 adds the editor of the curves, which is missing in 3.6.

Thanks to those who want to answer

Best regards

Franco Maria

0 Former HES Forums Member over 14 years ago

See the following:
forums.highend.com/showthread.php?t=5926
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 francomaria - Former HES Forum Member over 14 years ago

In the link I read that version 3.3 is ok.
In the console that is installed using the 3.6
problems?

thanks
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Former HES Forums Member over 14 years ago

I'm not aware of a version 3.6. Are you running on a WholehogII, or one of the Jands Hogs (Hog250, 500, 600 or 1000)?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 francomaria - Former HES Forum Member over 14 years ago

the consolle is wholehog2. this is sure.
I think the version is 3.6... but control.

Thank a lot

Franco Maria
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel