ETC - Community
Site
Search
User
Site
Search
User
Control Consoles
More
Legacy Consoles
Legacy - Wholehog 2
Wholehog 2 front panel flashing
Home
Forums
More
Cancel
State
Not Answered
Date
timmiller - Former HES Forum Member
Date
Mon, Apr 20 2015 1:07 PM
Replies
3 replies
Subscribers
4 subscribers
Views
217 views
Users
0 members are here
Wholehog 2 front panel flashing
I have a wholehog 2 in my shop and the LEDs on the front panel start flashing about 30 seconds after you turn on the console. All three power LEDs on the back are on. I also reseated all of the cables inside the console. When I power on the console there is a single led in the left center of the console that comes on but the 4 LEDs on the lower left side of the cpu are off along with one led above the group of 4. When I hold the reset button all 5 of the LEDs dimly glow and slightly flash.
Parents
0
mitch - Former HES Forum Member
over 6 years ago
The front panel and the processor are not communicating. It may be as simple as a cable but there may also be a component failing, or traces deteriorating on the processor board for example. They can take a while to find and sort out, if at all.
Cancel
Up
0
Down
Reply
Verify Answer
Cancel
Reply
0
mitch - Former HES Forum Member
over 6 years ago
The front panel and the processor are not communicating. It may be as simple as a cable but there may also be a component failing, or traces deteriorating on the processor board for example. They can take a while to find and sort out, if at all.
Cancel
Up
0
Down
Reply
Verify Answer
Cancel
Children
No Data
Related