ETC - Community
Site
Search
User
Site
Search
User
Control Consoles
More
Legacy Consoles
Legacy - Wholehog 2
Wholehog 2 front panel flashing
Home
Forums
More
Cancel
State
Not Answered
Date
timmiller - Former HES Forum Member
Date
Mon, Apr 20 2015 1:07 PM
Replies
3 replies
Subscribers
4 subscribers
Views
218 views
Users
0 members are here
Wholehog 2 front panel flashing
I have a wholehog 2 in my shop and the LEDs on the front panel start flashing about 30 seconds after you turn on the console. All three power LEDs on the back are on. I also reseated all of the cables inside the console. When I power on the console there is a single led in the left center of the console that comes on but the 4 LEDs on the lower left side of the cpu are off along with one led above the group of 4. When I hold the reset button all 5 of the LEDs dimly glow and slightly flash.
Parents
0
rob1980 - Former HES Forum Member
over 6 years ago
For future reference, mine was IC4 on the processor board, this is a floppy disk controller that also looks after the link to the front panel via IC73 (75155). I can change these if anyone should require it.
Cancel
Up
0
Down
Reply
Verify Answer
Cancel
Reply
0
rob1980 - Former HES Forum Member
over 6 years ago
For future reference, mine was IC4 on the processor board, this is a floppy disk controller that also looks after the link to the front panel via IC73 (75155). I can change these if anyone should require it.
Cancel
Up
0
Down
Reply
Verify Answer
Cancel
Children
No Data
Related