DP boot up

I'm still having days where the DP does not load show data upon console boot up. It just continues to read "Intializing..." but never gets to loading show. I wait about 4 or 5 minutes and then just restart the console. This is not every day, and it's not with every show file I create, but I'd say it's happened two or three times since buld 956 came out.

Wholehog 3 v1.3.8.6 (b956)
(2) DP2000s in network hub (only #1 has any patching right now)
Parents
  • 0
    I'd like to throw my 2 cents into this one.

    I am only running 1 console and 1 DP. About once every week, I get a "No Server" on the DP2000 upon startup of the console. The DP does not power down...only the console gets shut down at the end of the night. We always load the same show file. The only way to find it is a hard-reset on the DP2000.

    Setup:
    WHIII into Switch
    DP2000 into Switch
    ELC DMXNode4 into Switch
    Cat6 to backstage

    Backstage:
    ELCDMXNode4 outputing to Optos

    Jon
Reply
  • 0
    I'd like to throw my 2 cents into this one.

    I am only running 1 console and 1 DP. About once every week, I get a "No Server" on the DP2000 upon startup of the console. The DP does not power down...only the console gets shut down at the end of the night. We always load the same show file. The only way to find it is a hard-reset on the DP2000.

    Setup:
    WHIII into Switch
    DP2000 into Switch
    ELC DMXNode4 into Switch
    Cat6 to backstage

    Backstage:
    ELCDMXNode4 outputing to Optos

    Jon
Children
No Data
Related

www.etcconnect.com