Hi, I would like to know why there are 2 seconds of difference between the CD built inside and the LTC or MIDI timecode? when I use the cd to trigger cues in my shows and after I transpose the same timing on a MIDI timecode or a LTC timecode or a Simulate timecode, I find a latency about two seconds. note that the audio files on the CD and MIDI timecode and LTC time code is the same!!!! I think it's 'cause the CD fisical time to initialize the disk and then to read from the first track. It's possible to reduce this latency, without use a pc to read a wave track and the internal simulate Timecode to syncronize with the pc? It's very heavy!!!!!!!
The hog3 is not actually reading timecode off of an audio track on the CD (try putting in any ol audio cd and see what happens). It is using the time base embedded on every audio CD. This is probably why you're seeing this offset.
The hog3 is not actually reading timecode off of an audio track on the CD (try putting in any ol audio cd and see what happens). It is using the time base embedded on every audio CD. This is probably why you're seeing this offset.
