Hi, I would like to know why there are 2 seconds of difference between the CD built inside and the LTC or MIDI timecode? when I use the cd to trigger cues in my shows and after I transpose the same timing on a MIDI timecode or a LTC timecode or a Simulate timecode, I find a latency about two seconds. note that the audio files on the CD and MIDI timecode and LTC time code is the same!!!! I think it's 'cause the CD fisical time to initialize the disk and then to read from the first track. It's possible to reduce this latency, without use a pc to read a wave track and the internal simulate Timecode to syncronize with the pc? It's very heavy!!!!!!!
One thing that may be useful for you that isn't in the current manual is this:
You can offset the timecode values for an entire block of cues at one time. In the cuelist window, click and drag over the wait column for the cues you want to adjust. Press Set. Enter the new correct value for the cue that is being edited. The console will calculate the offset and apply this change to all of the selected cells.
One thing that may be useful for you that isn't in the current manual is this:
You can offset the timecode values for an entire block of cues at one time. In the cuelist window, click and drag over the wait column for the cues you want to adjust. Press Set. Enter the new correct value for the cue that is being edited. The console will calculate the offset and apply this change to all of the selected cells.
