Hi All,
I have a question about stopping an effect in a cue that follows the cue that contains the effect.
Here is the scenario:
I take my mid-stage Mac 700's and place the Tilt into a sine wave with an offset and all that fun stuff for cue 2. In Cue 3 I want to stop the movement.... I grab the groups, assign them a static position and record cue 3 with the desired timing. Using either Record/Merge or Merge/Cue Number the first recording does not stop the movement. If I repeat the same syntax over again and record it (or merge/cue # twice in a row with the initial selection) it stops. Alternatively When I make the selection I open the effect engine and select "off" for that parameter and it seems to do it first.
I guess I am just looking for the 'proper' and 'efficient' method for this!
Thanks!
Robb
