Wholehog 3 doesn´t respond to MSC

Hi,
I am having trouble when I send MSC to the Wholehog 3 console. I did every setup steps as recalled from the manual to enable the console to receive MSC, but while I send the MSC data it simply does nothing.
I am confident that my MSC device transmitter is working ok, and that the MSC data is the correct for the console. I also downloaded the Status Cue software ( I do not know of any other software simpler than this to view MSC in the PC via the MIDI In port), and it seems to receive every MSC command properly.
Are any MIDI event monitor in the Wholehog 3 console?
I suspect that I am only bypassing a simple configuration step to work properly with MSC in the console, but other that the Network panel settings I do not what could be.
Thank you very much for any help.
Parents
  • 0
    Thank you for your replys. I have sucessful GO'ed the Wholehog 3. However, I can`t send a STOP and RELEASE Midi Show control commands. According to the user manual the STOP and RELEASE only have one data byte (the cuelist number).

    For example for an MSC STOP for cuelist 1, I send the following data (assigned the ID to 1 of course):

    F0 7F 01 02 01 02 30 31 00 F7

    I send the 30 31 because I always send the numbers as tenths, units (because of my controller), and I believe that the 00 after F7 doesn't interfere with the message (it worked ok when I used the GO command).

    Thank you very much for any help.
Reply
  • 0
    Thank you for your replys. I have sucessful GO'ed the Wholehog 3. However, I can`t send a STOP and RELEASE Midi Show control commands. According to the user manual the STOP and RELEASE only have one data byte (the cuelist number).

    For example for an MSC STOP for cuelist 1, I send the following data (assigned the ID to 1 of course):

    F0 7F 01 02 01 02 30 31 00 F7

    I send the 30 31 because I always send the numbers as tenths, units (because of my controller), and I believe that the 00 after F7 doesn't interfere with the message (it worked ok when I used the GO command).

    Thank you very much for any help.
Children
No Data
Related

www.etcconnect.com