Parameter wheel path

Hi All

I want to know if there is a way to change to movement side of the parameter wheel (left or right)....i think...or something like that...

I will give example...

I have 2 cues, the first one is all Mac 500 open white and the seconed is all Mac 500 on Red.
*The Red colour on the Mac 500 is in the end of the colour wheel.
So if i playback the cues on Liner path, the Mac will go through all the colour in the colour wheel till it will get to Red.

My question is there a way to change the movment side of the colour wheel so the Red colour will be first, i mean the colour wheel will move left insted of right.

Thanks a lot guys

Amir
Danix.co.il
Israel
Parents
  • 0
    Amir,

    For fixtures which allow you to take the shortest path to a slot (like the MAC500), there should be an option called shortcut mode on the mode slots toolbar. Turning shortcut mode on should force the fixture to take the shortest path when fading between slots. Leaving it off (the default) will leave the behaviour up to the fixture.

    I believe that the MAC500 actually allows you to set the default behaviour for slotted wheel changes using the SPEC/SCUT menu option. You may want to check this in the manual and on the fixture.

    I hope this helps.
Reply
  • 0
    Amir,

    For fixtures which allow you to take the shortest path to a slot (like the MAC500), there should be an option called shortcut mode on the mode slots toolbar. Turning shortcut mode on should force the fixture to take the shortest path when fading between slots. Leaving it off (the default) will leave the behaviour up to the fixture.

    I believe that the MAC500 actually allows you to set the default behaviour for slotted wheel changes using the SPEC/SCUT menu option. You may want to check this in the manual and on the fixture.

    I hope this helps.
Children
No Data
Related

www.etcconnect.com