Moving up to Hog3 PC

I'm loading into a venue with a Hog II PC system setup. I want to run Hog III PC using their playback wing, programming wing and two touchscreen monitors. I have a Hog III superwidget so we should be good to go as far as outputting Hog III.

We've loaded and launched Hog III PC and we've run into two problems. The first unusual problem is that on the primary launch screen the buttons for Launch New Show and Launch exhisting show are greyed out. So regrardless of any other issues, we can't launch the software.

The second and more pressing problem is that the Hog III can't seem to find the programming wing. It's connected, the trackball works, but when we go to the control panel to set up wings, the wing doesn't appear so we can't assign it to the program.

Anyone have any suggestions?

-Rob
Parents
  • 0
    the first thing that comes to mind, is that if "Run server" is deselected in setting(you can find that on the initial screen) both launch existing, and launch new is greyed out.. this is by design, becouse if you don't have a server, you can't start a show..

    as for the second issue, I'm not shure, but i think the driver for the programmer wing is actually two drivers(anyone from HES would know!) the trackball comes up in windows as a standard input device(a mouse) so the trackball works always.. But i don't think the "proper" driver for the rest of the wing gets initiallized until hog3pc has come a little further in it's startup sequence than the first start window..And i actually don't think the programmer wing has it's own setting under wings in config(so it would make sense that you can't see it)
Reply
  • 0
    the first thing that comes to mind, is that if "Run server" is deselected in setting(you can find that on the initial screen) both launch existing, and launch new is greyed out.. this is by design, becouse if you don't have a server, you can't start a show..

    as for the second issue, I'm not shure, but i think the driver for the programmer wing is actually two drivers(anyone from HES would know!) the trackball comes up in windows as a standard input device(a mouse) so the trackball works always.. But i don't think the "proper" driver for the rest of the wing gets initiallized until hog3pc has come a little further in it's startup sequence than the first start window..And i actually don't think the programmer wing has it's own setting under wings in config(so it would make sense that you can't see it)
Children
No Data
Related

www.etcconnect.com