• State Not Answered
  • Date
    andyp - Former HES Forum Member
  • Date
  • Replies 6 replies
  • Subscribers 5 subscribers
  • Views 566 views
  • Users 0 members are here

Rem Dim

In the manual it says that to 'reverse' a rem-dim use the undo key, which is fine unless you want to rem-dim so that you can see to adjust pan & tilt. I know there's highlight but sometimes this doesn't always work, especially if you want to focus a gobo etc....

I might be missing something, but could you have 'pig+rem-dim' as an "undo" or "reverse" rem-dim function?

What's your thoughts/suggestions?
Parents
  • 0
    AndyP,


    I know what you mean. I intuitively held [PIG] + Rem Dim thinking that it would "reverse" the operation, but of course, I was wrong. I figure since allot of us as programmers are so use to using [PIG] to reverse certain commands its almost natural to think that [PIG] + Rem Dim is an available function. Guess we'll have to wait for the great debate in order to find out the fate of [PIG] + Rem Dim, but if you want my two cents it would be nice to have....
Reply
  • 0
    AndyP,


    I know what you mean. I intuitively held [PIG] + Rem Dim thinking that it would "reverse" the operation, but of course, I was wrong. I figure since allot of us as programmers are so use to using [PIG] to reverse certain commands its almost natural to think that [PIG] + Rem Dim is an available function. Guess we'll have to wait for the great debate in order to find out the fate of [PIG] + Rem Dim, but if you want my two cents it would be nice to have....
Children
No Data
Related

www.etcconnect.com