Color Command Electronic Strobing H3PC

Hi, everyone,

I've been playing with 3PC and the ESP Vision Demo (using the ESP demo show files) and I can't get the Color Commands to strobe above 10Hz. What am I missing here? I know their mode has to be set to Strobe Mode Electronic which I am doing by pressing Mode then Strobe Mode Electronic. Is there something else I have to do to put them in this mode? Thanks!

Will
Parents
  • 0
    Thanks, Marty! Could I edit the fixture to display the appropriate rate? Also, I'm not sure this is the correct way to describe what I'm looking for, but is there a way to look at the actual dmx values the console is outputting for the relevant parameters to perform a certain function in the fixture. For example, if I know that to make the fixture perform a certain function, I have to set the fifth dmx channel to between x and y, and set the sixth dmx channel to z, is there a way to check that the buttons on the Hog3 screen are in fact setting the dmx channels correctly? Thanks for the help!
Reply
  • 0
    Thanks, Marty! Could I edit the fixture to display the appropriate rate? Also, I'm not sure this is the correct way to describe what I'm looking for, but is there a way to look at the actual dmx values the console is outputting for the relevant parameters to perform a certain function in the fixture. For example, if I know that to make the fixture perform a certain function, I have to set the fifth dmx channel to between x and y, and set the sixth dmx channel to z, is there a way to check that the buttons on the Hog3 screen are in fact setting the dmx channels correctly? Thanks for the help!
Children
No Data
Related

www.etcconnect.com