Is it wyg R22 or...?

Hi there,

3 searching and experiment weeks later, I can't connect wysiwyg R22 and an Ipc (Hog3pc mode) or a road hog full boar.:dunno:

All devices are DHCP
I can ping consoles by my computer
I can connect Hog3pc on my computer with console
So I think it's a wysiwyg problem. No firewall installed and all port open in my netgear routeur.
On wholehog connectivity driver :
Status : Locating Wholehog Network
Session :
Info : Scanning port 6600
Configuration
Port 6600
User Number 1 (I didn't understand what is it)
v1.08

I can connect Hog3pc and wyg R22 on the same compu...:Eyecrazy:

Really no idea at all,
Need a serious help
Thanx
Parents
  • 0
    From my little experience of using wysiwyg and an IPC.

    Connect the IPC and the machine running wyg to a simple unmanaged "switch",i found routers to more complicated than required or try connecting the IPC and wyg machine using a crossover cable as a last resort.
    Give the machine running wyg an IP address in the same range as your IPC console.
    Have alook at your network setting of your IPC to get this aaddress.
    Disable all antivirus software.

    Make sure the IPC is not using the loopback adaptor to try and connect to a show.
    Make sure the wyg machine is not connecting using the loopback adaptor either.
    If you wanted to to uninstall the connectivity driver and re-install it might not hurt.
    hope this is of some help,

    C
Reply
  • 0
    From my little experience of using wysiwyg and an IPC.

    Connect the IPC and the machine running wyg to a simple unmanaged "switch",i found routers to more complicated than required or try connecting the IPC and wyg machine using a crossover cable as a last resort.
    Give the machine running wyg an IP address in the same range as your IPC console.
    Have alook at your network setting of your IPC to get this aaddress.
    Disable all antivirus software.

    Make sure the IPC is not using the loopback adaptor to try and connect to a show.
    Make sure the wyg machine is not connecting using the loopback adaptor either.
    If you wanted to to uninstall the connectivity driver and re-install it might not hurt.
    hope this is of some help,

    C
Children
No Data
Related

www.etcconnect.com