HOG iPC Networking ?????

[quote=Chrislim]Question one
How can I hook up the following
1 x HOG iPC ( Show Console )
1 x PC running HOG3PC V3.0 ( Back UP )
1 x PC Running WYSIWYG R22 ( Visualizer )
Pls advise me what gears should I get to make it happen .

You are going to want an ethernet switch and straight Cat5 cables to connect all three of these.

Assign your H3PC and WYg computers static IPs in the same range as your iPC, or use the DHCP boot server available from the Network config on the iPC.

If you want your H3PC as a secondary (client) console, make sure to disable "Run Server" and set a different console number than your iPC (usually "2" or greater is fine).

[quote=Chrislim]Question Two
How can I get my HOG 2 Effects convert to be able to use in HOG 3
As I got quite some Effects that we created .

You can't....custom effect tables are currently not available with H3 software....it is logged as an enhacement though.

Hope this helps:)

[quote=Chrislim]Question one
How can I hook up the following
1 x HOG iPC ( Show Console )
1 x PC running HOG3PC V3.0 ( Back UP )
1 x PC Running WYSIWYG R22 ( Visualizer )
Pls advise me what gears should I get to make it happen .

You are going to want an ethernet switch and straight Cat5 cables to connect all three of these.

Assign your H3PC and WYg computers static IPs in the same range as your iPC, or use the DHCP boot server available from the Network config on the iPC.

If you want your H3PC as a secondary (client) console, make sure to disable "Run Server" and set a different console number than your iPC (usually "2" or greater is fine).

[quote=Chrislim]Question Two
How can I get my HOG 2 Effects convert to be able to use in HOG 3
As I got quite some Effects that we created .

You can't....custom effect tables are currently not available with H3 software....it is logged as an enhacement though.

Hope this helps:)