Losing Fixtures (homing up)

I just setup a show with the new software 3.0.0 and as I was wringing out the system I noticed that I would have to grab and shake some fixtures before they would "Home" down. At one point I went away for about an hour and when I came back about half the rig was homed up again. The units immediatly find themselves if either pan or tilt is touched. Is this some kind of DMX hickup I am getting with the new software? Nothing else on this system has changed so I am not sure what else this could be.

I am using a Whole Hog III with Playback Wing and 2 External Monitors and a DP 2000 with the following fixtures patched;
12 Mac 2k Profiles
12 Mac 2k Washes
12 575 Studio Spots
12 575 Studio Colors

This problem is not isolated to any one type of fixture. I am routed through an Iso Splitter on each of the three moving light universes in the DP 2000 but I have never had this problem with this system before. Any suggestions?
Parents
  • 0
    IPC: 3.01
    attched devices : wing/superwidget/usb keyboard

    Hi,
    i'm sure you know this is happening but i saw this yesterday for the first time.
    Changing from mac 700 spot to Clay paky Alpha wash 575.
    Fixture 102 became unresponvie after change type with the only fix being to log off and restart the show.

    I've got another 15 shows in the next few weeks with change type will this happen with every show?

    Cheers Cormac
Reply
  • 0
    IPC: 3.01
    attched devices : wing/superwidget/usb keyboard

    Hi,
    i'm sure you know this is happening but i saw this yesterday for the first time.
    Changing from mac 700 spot to Clay paky Alpha wash 575.
    Fixture 102 became unresponvie after change type with the only fix being to log off and restart the show.

    I've got another 15 shows in the next few weeks with change type will this happen with every show?

    Cheers Cormac
Children
No Data
Related

www.etcconnect.com