Effects and IPCB fadres

Hey,

I have been reading around about assigning parameters of effects to IPCB faders, but i was wondering if that fader only applies to that specific effect or to any effect containing the paramater?

The way I would like to set up my show is to have one page with each fader to control the rate,size, and offset of an any effect applied to a specific paramerter.

For instance,

Page 1
fader1-rate for all pan/tilt effects
fader2-size for all "" effects
fader-3 offset for all "" Effects
Fader-4 Rate for all color effects
and so on.
Parents
  • 0
    I have a similar problem.
    Is it able to safe for example only different speeds to the effect palette?

    Example: I have a mover turning a circle an now I want to change the speed of Pan/Tilt. So far I'm turning the speed wheel life or typing the speed into the effect table.
    But it would be nicer to have a button that changes only the speed values.


    Another problem with fx:
    Cue 1: running on a master, for example a circle
    How can I stop the circle in the programmer without releasing the master?
    According to my logic it should work to set the relevant effect "off". But that doesn't work :dunno:
    I always have to release the master.

    I wish to have a button in the fx palette with "all fx off". Is that possible?

    Greetings,
    Ben
Reply
  • 0
    I have a similar problem.
    Is it able to safe for example only different speeds to the effect palette?

    Example: I have a mover turning a circle an now I want to change the speed of Pan/Tilt. So far I'm turning the speed wheel life or typing the speed into the effect table.
    But it would be nicer to have a button that changes only the speed values.


    Another problem with fx:
    Cue 1: running on a master, for example a circle
    How can I stop the circle in the programmer without releasing the master?
    According to my logic it should work to set the relevant effect "off". But that doesn't work :dunno:
    I always have to release the master.

    I wish to have a button in the fx palette with "all fx off". Is that possible?

    Greetings,
    Ben
Children
No Data
Related

www.etcconnect.com