Df-50 Hazer

Hello,

I am trying to setup a DF-50 Hazer (older model no DMX) to be controlled by the hog system. Would it be possible to plug the power for the Hazer into a dimmer and then patch it as a non-dimmable fixture? I tried this but on the hog the intensity just stays at 0. I guess what I am asking is, is there a way to have a fixture so the power is either 0 or 100 no values in between?

Thanks,

kmkarim

Parents

0 robert26 - Former HES Forum Member over 15 years ago

We put DF-50's on dimmers all the time without issue. We set dimmer 48 on out sensor touring racks to the switched mode. you can then run it as a desk channel or a non-dim. I have done it both ways.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 robert26 - Former HES Forum Member over 15 years ago

We put DF-50's on dimmers all the time without issue. We set dimmer 48 on out sensor touring racks to the switched mode. you can then run it as a desk channel or a non-dim. I have done it both ways.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data