New to Lighting need help on some questions~

Hi everybody,

I'm just hired in a club as Lighting assistant, I got a few question need to be answer for me to learn more and play the light to its fullest potential.

1: How can i connect Hog3PC to the RoadHog console?? (is there a converter cabble or device needed?)
2: Is it possible for me to use the RoadHog console as a control surface for the Hog3PC show??
3: Can i copy the show i've programmed in Hog3PC to the RoadHog console to use it??

Anybody willing to teach me about this is highly appreciated...
thanks :)


p/s: pardon me if my grammar is not that good.
Parents
  • 0
    [quote=ffmichael;39989]The club is using 2 RoadHog console.. not the Full Boar version,

    1: So means the only thing i can do is to transfer the showfile from 3PC to the console right?

    Pretty much, yes.

    [quote=ffmichael;39989]
    2: All I have to do is done all the programming in the 3PC by following the grouping in the console and just program cues or palettes correct?

    thank you all for answering my question~ cheers :friday:

    Anything you can do on the console, you can do in 3PC. My advice would be to add all your fixtures in 3PC, make all your palettes and groups in there, then when you have done everything you need to do, load it onto the console (using the USB flash drive). You could program your show entirly on either the console or 3PC. It doesnt really matter. But when you are playing back, you obviously need real fixtures, so you would then load the show onto the console.

    Does that make sense? :)
Reply
  • 0
    [quote=ffmichael;39989]The club is using 2 RoadHog console.. not the Full Boar version,

    1: So means the only thing i can do is to transfer the showfile from 3PC to the console right?

    Pretty much, yes.

    [quote=ffmichael;39989]
    2: All I have to do is done all the programming in the 3PC by following the grouping in the console and just program cues or palettes correct?

    thank you all for answering my question~ cheers :friday:

    Anything you can do on the console, you can do in 3PC. My advice would be to add all your fixtures in 3PC, make all your palettes and groups in there, then when you have done everything you need to do, load it onto the console (using the USB flash drive). You could program your show entirly on either the console or 3PC. It doesnt really matter. But when you are playing back, you obviously need real fixtures, so you would then load the show onto the console.

    Does that make sense? :)
Children
No Data
Related

www.etcconnect.com