Question on cue timming

question on HOG3 iPC, and cues timing.

I looked thru all of the manual to find the answer but could not find it.

When I go into the cue list under FADE, I see the following info for one of my cue times:

2s,3s,5s

Does this mean 2s release time, 3s fade for all, and 5s wait?

Also, how would I input this "timming" with out a ", coma" into the command line?

Parents

0 misebeam - Former HES Forum Member over 15 years ago

Okay that makes sense, I would save times last night into a list and close, and then when I would open the list again, I would have 2s listed in all cues (2s,5s), even though I defined the cue time for each cues fade time. I did not affect the cue running, but kept showing up. If i were to use the command line, would I have to put a "+" between all diffent parameters?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 misebeam - Former HES Forum Member over 15 years ago

Okay that makes sense, I would save times last night into a list and close, and then when I would open the list again, I would have 2s listed in all cues (2s,5s), even though I defined the cue time for each cues fade time. I did not affect the cue running, but kept showing up. If i were to use the command line, would I have to put a "+" between all diffent parameters?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data