Easy way to state time for a fixture parms

Still a noobie,

Is there an easy way to state time for a fixture for color, beam, and position in one command?

I tried:
Postion+colour+beam time 0s for a 0 second fade to make my Mark cues run faster.

But up until I get to the “time” in seconds, the command turns Red.

Thanks
Parents
  • 0
    Ohh.. furthermore... If certain parameters are going to have the same timing, you could use this syntax too...

    [Fixture] [1] [intensity] [position] [time] [4] [enter]. That will apply a fade time of 4 seconds to the intensity and position of fixture 1.

    But like I say, that only works if the parameters have the same time value, you still cannot have different time values in the same command.

    Best,
Reply
  • 0
    Ohh.. furthermore... If certain parameters are going to have the same timing, you could use this syntax too...

    [Fixture] [1] [intensity] [position] [time] [4] [enter]. That will apply a fade time of 4 seconds to the intensity and position of fixture 1.

    But like I say, that only works if the parameters have the same time value, you still cannot have different time values in the same command.

    Best,
Children
No Data
Related

www.etcconnect.com