Easy way to state time for a fixture parms

Still a noobie,

Is there an easy way to state time for a fixture for color, beam, and position in one command?

I tried:
Postion+colour+beam time 0s for a 0 second fade to make my Mark cues run faster.

But up until I get to the “time” in seconds, the command turns Red.

Thanks
Parents
  • 0
    [quote=jxgriffi;40403]Correct...if doing DIFFERENT times, it must be separated. Only if they are all the same time does my way work.

    Thats what I said... :Eyecrazy:

    [quote=Joe Bleasdale;40400]Ohh.. furthermore... If certain parameters are going to have the same timing, you could use this syntax too...

    But like I say, that only works if the parameters have the same time value, you still cannot have different time values in the same command.
Reply
  • 0
    [quote=jxgriffi;40403]Correct...if doing DIFFERENT times, it must be separated. Only if they are all the same time does my way work.

    Thats what I said... :Eyecrazy:

    [quote=Joe Bleasdale;40400]Ohh.. furthermore... If certain parameters are going to have the same timing, you could use this syntax too...

    But like I say, that only works if the parameters have the same time value, you still cannot have different time values in the same command.
Children
No Data
Related

www.etcconnect.com