Networking Protocal/ Full source code

Hey All,
[INDENT]I have been on the internet for a while looking for either the source code (for a linux install) or just a lib with the network protocol that Hog 3pc uses to talk with all other hog devices, but I can't find anything. Not even a basic "this is how this talks to this" type documentaion. Even a API would be nice,


thanks for the help
[/INDENT]
Parents
  • 0
    Michandrz-

    The Hog-Net protocol is not open-source and therefore not publicly available.

    As far as I know there is not a public API for communicating with Hog 3 software or devices. Barco/High End Systems/Flying Pig Systems works directly with specific software manufacturers - such as those who make pre-visualization products - to enable communication with these products.

    There are pages of the manual and posts on this forum with information regarding the default ports that are used by the software.

    Regards,

    Phil
Reply
  • 0
    Michandrz-

    The Hog-Net protocol is not open-source and therefore not publicly available.

    As far as I know there is not a public API for communicating with Hog 3 software or devices. Barco/High End Systems/Flying Pig Systems works directly with specific software manufacturers - such as those who make pre-visualization products - to enable communication with these products.

    There are pages of the manual and posts on this forum with information regarding the default ports that are used by the software.

    Regards,

    Phil
Children
No Data
Related

www.etcconnect.com