DP 8000 Databaseload faild

DP 8000 Databaseload faild

One of my DP8000 has a problem.

The DP8000 don’t starts up, he’s not getting true the start up screen.

I started up a Hog3 running V3.1.3, and connected the DP8000
I Forced the software in the DP8000

The DP8000 loaded the software and starts up
The controlpanel shows V3.1.3

When I try to get the DP8000 in the show (IP addresses in the same range) the DP800 shows: databaseload faild.

Is there a way to get this working again?

Parents

0 rutger harmsen - Former HES Forum Member over 15 years ago

To check my network I installed 2 DP2000

Hag3 IP 172.31.0.1 (use defult IP settings, Enable Boot Server only)

Wagner switch

DP2000 net# 1 IP 172.31.0.2
DP2000 net # 2 IP 172.31.0.3
DP8000 net # 3 IP 172.31.0.4

The DP2000 are running and in the show
The DP8000 is scanning the network while the IP settings wore not in the same range, however, when it is in the same range its get real slow, and it gives the error Databaseload faild
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 rutger harmsen - Former HES Forum Member over 15 years ago

To check my network I installed 2 DP2000

Hag3 IP 172.31.0.1 (use defult IP settings, Enable Boot Server only)

Wagner switch

DP2000 net# 1 IP 172.31.0.2
DP2000 net # 2 IP 172.31.0.3
DP8000 net # 3 IP 172.31.0.4

The DP2000 are running and in the show
The DP8000 is scanning the network while the IP settings wore not in the same range, however, when it is in the same range its get real slow, and it gives the error Databaseload faild
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data