dp 8000 not booting

We were updating hog 3 from 3.1.2 to 3.1.4.
Console software updated ok and working.
Dp2000 software updated ok and working.

Then the dp 8000 didn´t start to update.
So we tried forcing with pressing left button from dp8k when powerup. Nothing.
We ended up trying pressing all three buttons while powerup.
End result was that the dp8k isnt booting up any more at all.

If it is booted with all 3 buttons pressed the following happens:

First there is a lot of boot info runnning and eventually it goes to loop written below:

PXELINUX 3.71 3.71 Copyri
ght (C) 1994-2008 H. Peter
Anvin
Loading dp8000/vmlinuz-2.6
.26.5-dp.8k.....................
........................
Loading dp8000/intramfs-d
p87k_1.0_i386.cpio.gz........
.............................
.............................
....................
I/O Board Disconnected

At this point the Hog-Net Link light turns off and back on in approx 5 secs.


I/O Board Connected

And then dp goes back to beginnig of PXE... (loop above)


Then if is just turned on OR hard reseted (with center and right while poweron) a lot of info comes and everything stops to:

eth0: 10/100 speed: disabling TSO

and then nothing...

Havent had similar problems previously.
DP8k worked just fine before this.

Any ideas? Running out of buttons to press while powerup...
Parents
  • 0
    Eric:
    details about setup:
    Hog3+dp8k in network with 10/100/1000 switch.
    Connected to hog3: 10 fader usb wing, 2 monitors.
    We had custom ip's first when we had this problem.
    With this setup we tried 1 button and 3 button boot to dp.

    Then we changed to default ip settings and direct connection with crosscable. Same result. At this point the dp didn't wake up to any software any more, so we couldn't make changes to dp menu setup. Tried 1 and 3 button boots, details in previous messages.
Reply
  • 0
    Eric:
    details about setup:
    Hog3+dp8k in network with 10/100/1000 switch.
    Connected to hog3: 10 fader usb wing, 2 monitors.
    We had custom ip's first when we had this problem.
    With this setup we tried 1 button and 3 button boot to dp.

    Then we changed to default ip settings and direct connection with crosscable. Same result. At this point the dp didn't wake up to any software any more, so we couldn't make changes to dp menu setup. Tried 1 and 3 button boots, details in previous messages.
Children
No Data
Related

www.etcconnect.com