Programming wing problems

Hi guys, I hope you can help me with this one. I,ve been running Hog3PC with a usb prog wing on my computer without any problems. Then I bought another prog wing that was sligtly older, and when i use this wing on the same computer and software it acts strange. The cursor jumps around on the screen, and the programming weels on top of the wing doesn,t respond as they should. I have trided to reinstall the drivers on the computer without any luck, so I,m wondering if the problems are caused by the fact that it,s an older model? Any good advice out there?

Gorm
Parents
  • 0
    Hi.
    I,ve tried to use it on another computer, and change the powersupply, but the problems are the same. I,ve also tried to connect my other wing to the same computers, and it works like a charm. So I,m pretty shure it,s some kind of hardwareproblem. But this wing thats having trouble looks to be older than the other one I have, cause the letters on the keys look a bit different..

    The cursor starts moving around by itself the as long as the wing is connected. The moment I disconnect the wing it stops. It also makes it diffucult to place the cursor at something.

    Should I be worried, or is there some kind og firmware upgrade avabile?

    Gorm
Reply
  • 0
    Hi.
    I,ve tried to use it on another computer, and change the powersupply, but the problems are the same. I,ve also tried to connect my other wing to the same computers, and it works like a charm. So I,m pretty shure it,s some kind of hardwareproblem. But this wing thats having trouble looks to be older than the other one I have, cause the letters on the keys look a bit different..

    The cursor starts moving around by itself the as long as the wing is connected. The moment I disconnect the wing it stops. It also makes it diffucult to place the cursor at something.

    Should I be worried, or is there some kind og firmware upgrade avabile?

    Gorm
Children
No Data
Related

www.etcconnect.com