copying parameters

Tommi,

The easiest way to copy individual parameters between fixtures might be by right-clicking in the appropriate cell of a programmer window and copying, then pasting that to other fixtures in the same manner.

I believe this will work for any parameter.

Section 15.3.8 lays out the various ways to copy parameters using the command line.

So, based on the recommendation of the manual, the other (or maybe best) way to do this is as follows...

(This assumes none of these fixtures are currently in your programmer.)

If you want to copy Zoom from fixture 1 to fixtures 2-5:

- Select fixture 1
- 'Touch' or 'Pig+Touch' the Zoom wheel
- Type 'Copy 2 THRU 5 Enter'

This will copy any values which are in the programmer for the selected fixture.

Please let me know if you need any clarification on this.

Regards,

Phil

Tommi,

The easiest way to copy individual parameters between fixtures might be by right-clicking in the appropriate cell of a programmer window and copying, then pasting that to other fixtures in the same manner.

I believe this will work for any parameter.

Section 15.3.8 lays out the various ways to copy parameters using the command line.

So, based on the recommendation of the manual, the other (or maybe best) way to do this is as follows...

(This assumes none of these fixtures are currently in your programmer.)

If you want to copy Zoom from fixture 1 to fixtures 2-5:

- Select fixture 1
- 'Touch' or 'Pig+Touch' the Zoom wheel
- Type 'Copy 2 THRU 5 Enter'

This will copy any values which are in the programmer for the selected fixture.

Please let me know if you need any clarification on this.

Regards,

Phil