3.1.7. b2826 Problems with USB LTC Widgit.

Name: Justin
Date: Oct.16.2010
Software Version and build number: 3.1.7 b2826
Number of external displays:2
Connected USB Devices: USB LTC Widgit
Networked Devices: 2 - DP2000
Detailed description of the problem:

Upgraded from version 2.3.0 software on the hog 3. After managing to complete the upgrade i noticed problems with the LTC Widgit in regards to receiving Time code. It would work just after booting up the board, but then after a while of not receiving code it seemed to not acknowledge when code was being run again. Ended up running the show manually and then rolled back to 3.1.5. Everything seems to be running fine now.
Parents
  • 0
    Hey Eric.
    The Time Code Signal is fine as the Forward LED is on continuously, so I know that's not the problem. I've heard from other people that were using the same setup as me that they had to roll back as far as 2.2.2 to get the widget working properly. Does High End still produce the IO processor? As I can't find it on the site. Also my Zip disk isn't working properly as a result of rolling back to 2.6.0, so I'm going to roll forward in increments and hopefully get everything playing nicely together. I can't go all the way to 3.1.5 cause thats where the problems started but I'll go as far as I can.

    Any other suggestions?
Reply
  • 0
    Hey Eric.
    The Time Code Signal is fine as the Forward LED is on continuously, so I know that's not the problem. I've heard from other people that were using the same setup as me that they had to roll back as far as 2.2.2 to get the widget working properly. Does High End still produce the IO processor? As I can't find it on the site. Also my Zip disk isn't working properly as a result of rolling back to 2.6.0, so I'm going to roll forward in increments and hopefully get everything playing nicely together. I can't go all the way to 3.1.5 cause thats where the problems started but I'll go as far as I can.

    Any other suggestions?
Children
No Data
Related

www.etcconnect.com