• State Not Answered
  • Date
    ottot - Former HES Forum Member
  • Date
  • Replies 11 replies
  • Subscribers 5 subscribers
  • Views 344 views
  • Users 0 members are here

Mac 700 Profile strobe channel weirdness

Hi there,

I´m working on a musical production which premiere is running on this same moment. For some reason our Mac 700 profiles strobe channel is acting quite strange way. When i set fixtures at full and add strobe nothing happens but after few seconds intensity fades smoothly out. If i knockout strobe parameter, intensity comes back at full. Strobe channel did work at wednesday when i created pallets to our LD. Today, i also tried to create a clean show and i did patch only few Mac 700 but same problem appears.
Any idea what could cause this? All our other fixtures, Mac III Performances, Tw-1s and VL2500 washes are working just fine.

We are using one Wholehog III (3.1.7) with miniwing and one quite fully loaded DP2000.
There are also two monitors and keyboard connected.
_______
ottot
Parents
  • 0
    Hi Marty,

    I have tried "Check Integrity" and im quite sure this is not programming based issue.
    I tried to create a new show, patched few Mac 700s and problem were still
    there. After that, i did unpatch whole DP and replaced one fixture with desk channels
    and that way i could operate shutter and strobe channel. Of cource i cant do that
    trick to our showfile. :)

    So problem could be in fixture library on in the 3.1.7 software version, but i have
    tried to reinstall them both. Is it possible to run a show file with software
    ver 3.1.6 if it has been programmed on a 3.1.7?
    _______
    ottot
Reply
  • 0
    Hi Marty,

    I have tried "Check Integrity" and im quite sure this is not programming based issue.
    I tried to create a new show, patched few Mac 700s and problem were still
    there. After that, i did unpatch whole DP and replaced one fixture with desk channels
    and that way i could operate shutter and strobe channel. Of cource i cant do that
    trick to our showfile. :)

    So problem could be in fixture library on in the 3.1.7 software version, but i have
    tried to reinstall them both. Is it possible to run a show file with software
    ver 3.1.6 if it has been programmed on a 3.1.7?
    _______
    ottot
Children
No Data
Related

www.etcconnect.com