I tried to change the location of the Fade (top,bottom, etc) from the blur menu within beam. I want them to show up in intensity ONLY. So, I put them into intensity, and took them out of the beam tab ... why do they keep showing up at the end of the beam menu when I select the fixture?
[QUOTE=stephenwyker;53055]The issue with the blank thing is then when I use any other fixture that doesn't have it; it screws up all of their beam pages. Yep....that's exactly what I mean by tricky.....it can take quite a lot of trial and error to figure out the correct combination of parameters on any given line as well as where to insert "-blank-" and where not to.
[QUOTE=stephenwyker;53055]Yes, I have searched throughout the beam list and no fades ... LOL. I have spend months (actually years now) perfecting my house wheel sets so I can pretty much program eyes closed and know where the perimeters will fall. This is just driving me nuts! I actually looked at the newest wheels sets on my computer while programming them on my hog III; this way I could mesh them into my current library. My show files was just merged a few days back to contain the newest library.
Sounds to me like something old is being carried over. If you launch a new show do you have the same issue? This will tell you if it is showfile specific or somewhere in your preferences file.
[QUOTE=stephenwyker;53055]The issue with the blank thing is then when I use any other fixture that doesn't have it; it screws up all of their beam pages. Yep....that's exactly what I mean by tricky.....it can take quite a lot of trial and error to figure out the correct combination of parameters on any given line as well as where to insert "-blank-" and where not to.
[QUOTE=stephenwyker;53055]Yes, I have searched throughout the beam list and no fades ... LOL. I have spend months (actually years now) perfecting my house wheel sets so I can pretty much program eyes closed and know where the perimeters will fall. This is just driving me nuts! I actually looked at the newest wheels sets on my computer while programming them on my hog III; this way I could mesh them into my current library. My show files was just merged a few days back to contain the newest library.
Sounds to me like something old is being carried over. If you launch a new show do you have the same issue? This will tell you if it is showfile specific or somewhere in your preferences file.
