FX problem after updating a cue

I have an pan FX with low speed and small size (like 2bpm, 3 degrees)
After updating something (like a desk channel intensity) to the cue the effect does not run smoothly anymore.

The cue I'm updating has the FX as tracked information.
If I run the cue what is the source of FX and then the cues with tracked information, it runs smoothly again.
Also if I suck the FX to the programmer from the cue, it runs smoothly.

I haven't tried what happens if the FX is recorded as hard values.

But it seems the console has problems asserting the cue with tracked FX after updating.

Parents

0 rautasami over 14 years ago

I'm running 3.2.1
That jumpy FX seems to happen also when recorded just the normal way.
I have Sin in P and T speed 3 size 3 in 4 VL3500 spots.
Offset 25, 225, 104, 306
The FX runs smooth from programmer, but gets jumpy when played from cue.
The strange FX behaviour can be seen also in output window.
Maybe I should send you the showfile.

Reply

0 rautasami over 14 years ago

I'm running 3.2.1
That jumpy FX seems to happen also when recorded just the normal way.
I have Sin in P and T speed 3 size 3 in 4 VL3500 spots.
Offset 25, 225, 104, 306
The FX runs smooth from programmer, but gets jumpy when played from cue.
The strange FX behaviour can be seen also in output window.
Maybe I should send you the showfile.

Children

No Data