• State Not Answered
  • Date
    rautasami
  • Date
  • Replies 18 replies
  • Subscribers 5 subscribers
  • Views 983 views
  • Users 0 members are here

FX problem after updating a cue

I have an pan FX with low speed and small size (like 2bpm, 3 degrees)
After updating something (like a desk channel intensity) to the cue the effect does not run smoothly anymore.

The cue I'm updating has the FX as tracked information.
If I run the cue what is the source of FX and then the cues with tracked information, it runs smoothly again.
Also if I suck the FX to the programmer from the cue, it runs smoothly.

I haven't tried what happens if the FX is recorded as hard values.

But it seems the console has problems asserting the cue with tracked FX after updating.
Parents
  • 0
    [QUOTE=srautane;56615]I kind of found the reason for this problem. I powered off the DP number 3 and everything seems to run fine. Could this be a somekind of sync issue when DPs are outputting the same?

    Do you have two DPs outputting the same ArtNet data on the same system?

    This could certainly bring down a system in a hurry since your ArtNet recievers wouldn't know which source to pay attention to first.

    If you need ArtNet redundacy @ the DP level you need a network A/B switch.

    Hope this helps. :)
Reply
  • 0
    [QUOTE=srautane;56615]I kind of found the reason for this problem. I powered off the DP number 3 and everything seems to run fine. Could this be a somekind of sync issue when DPs are outputting the same?

    Do you have two DPs outputting the same ArtNet data on the same system?

    This could certainly bring down a system in a hurry since your ArtNet recievers wouldn't know which source to pay attention to first.

    If you need ArtNet redundacy @ the DP level you need a network A/B switch.

    Hope this helps. :)
Children
No Data
Related

www.etcconnect.com