• State Not Answered
  • Date
    Richard Harrison
  • Date
  • Replies 3 replies
  • Subscribers 5 subscribers
  • Views 249 views
  • Users 0 members are here

Rig check Keystroke Macro?

Hi all

A bit new to macros, is there a way i can write a rig check macro?
I would like @ 30% to trigger desk channel 1 and loop and continue through desk channels then through fixture numbers leaving everything on at 30%.

I can't seem to repeat the macro step when I select "macro" within the command line once I have begun recording the macro it defaults to desk channel. I have tryed the following:

e.g Record Macro 1 "@30% next enter macro 1 enter" Pig Macro

Any help would be ace and bring you good Xmas karma....:notworthy:
Parents
  • 0
    POSSIBLY...try triggering a cuelist that selects all fixtures/channels then triggers the macro in the comments section
    Delete the first 2 steps of the macro "Recall view/clear"
    The macro could be along the lines of: Next @ 30% GL??
    with list ?? triggering the macro once again

    I'm not sure how you'd stop this cycle...possibly a release all macro...

    However I don't know if this approach would be a great idea for console stability, I'm sure someone wiser could advice on whether this is a good idea or not


    Gordo
Reply
  • 0
    POSSIBLY...try triggering a cuelist that selects all fixtures/channels then triggers the macro in the comments section
    Delete the first 2 steps of the macro "Recall view/clear"
    The macro could be along the lines of: Next @ 30% GL??
    with list ?? triggering the macro once again

    I'm not sure how you'd stop this cycle...possibly a release all macro...

    However I don't know if this approach would be a great idea for console stability, I'm sure someone wiser could advice on whether this is a good idea or not


    Gordo
Children
No Data
Related

www.etcconnect.com