RHFB Crash

Setup Information
1x Road Hog Full Boar 3.2.3 b3367
1x USB Keyboard

I recently upgraded my Road Hog Full Boar to 3.2.3 from 3.1.5 going through a clean install. When I recreated the show I started with a blank show in 3.2.3 and merged in the information from the old show. Yesterday while programming the desk crashed twice and the only thing that would fix it was a hard reset.

At the time of the crashes the playback had some basic lists running and effects were either being driven by the playback lists or in the programmer. I would select a group of fixtures and then Highlight the group, put the cursor in ball mode, and scroll through the fixtures one by one using next/back (left click/right click). The crash occurred if I did all these steps in quick succession.

I didn't check if a dump file was created but the show file can be provided if necessary.
Parents
  • 0
    I experienced a very similar series of crashes yesterday.
    Roadhog FullBoar, updated to 3.2.3 b3367 yesterday morning.

    Everything was fine for ~2 hours of programming. Then when I would go into blue ball mode, and press UPDATE to update a cue, all the front panel buttons, including playback faders would stop responding. My keyboard still worked, and I could pull up the task manager window, but that showed all processes still running. I restarted the console from this window, and when I tried to continue programming, the lock up happened at the same point..blue ball > UPDATE key. We needed to finish programming, so we rolled back to 3.2.2 b 3337, and everything was back to normal, no hiccups. This would indicate its probably the software release, and not the physical buttons.
Reply
  • 0
    I experienced a very similar series of crashes yesterday.
    Roadhog FullBoar, updated to 3.2.3 b3367 yesterday morning.

    Everything was fine for ~2 hours of programming. Then when I would go into blue ball mode, and press UPDATE to update a cue, all the front panel buttons, including playback faders would stop responding. My keyboard still worked, and I could pull up the task manager window, but that showed all processes still running. I restarted the console from this window, and when I tried to continue programming, the lock up happened at the same point..blue ball > UPDATE key. We needed to finish programming, so we rolled back to 3.2.2 b 3337, and everything was back to normal, no hiccups. This would indicate its probably the software release, and not the physical buttons.
Children
No Data
Related

www.etcconnect.com