Connecting Artistic Licence ArtNet box to Full Boar

Hi,

I think I am being a bit stupid but I am having real trouble connecting my Artistic Licence ArtNet box to the Hog. I have used this bo in the past using a Vista T2 and had no worries so I understand how the general concept works etc.

The box is connected to the hog using a cat5 cable. The hog is 'seeing' the box when I press 'set up' and 'network' and so will let me say that output 1 is subnet 1 universe 1 etc etc (I need to us 9 of the 12 availalbe outputs on the artnet box).

When I patch a fixture and want to assign the fixture to a specific universe/port on the artnet box, I am not given the option to path it there. Instead I simply get the usual DP1 option to hard patch to the desk.

any help on this please? Or is someone can write an idiots guide to patching fixtures to artnet universes for me then that would be good!

Cheers
Parents
  • 0
    cheers for that.

    I still seem to be having trouble though. Whilst the DP8000 is connecting to the hog, the desk isnt seeing the ArtNet box. The box is getting a network signal however that is as far as it goes really.

    Basically I need my show to run on 17 universes of DMX. the first 8 of these can be from the DP8000 and then I need to run the remaining 9 from the 12 way artnet box. How do i configure the artnet box to have 'ouput 1 = dmx universe 9' and 'output 2 = dmx universe 10' etc etc

    :1zhelp:
Reply
  • 0
    cheers for that.

    I still seem to be having trouble though. Whilst the DP8000 is connecting to the hog, the desk isnt seeing the ArtNet box. The box is getting a network signal however that is as far as it goes really.

    Basically I need my show to run on 17 universes of DMX. the first 8 of these can be from the DP8000 and then I need to run the remaining 9 from the 12 way artnet box. How do i configure the artnet box to have 'ouput 1 = dmx universe 9' and 'output 2 = dmx universe 10' etc etc

    :1zhelp:
Children
No Data
Related

www.etcconnect.com