DP2000 / Artnet Mode

Hi, Apologies if this is the wrong thread for this, I couldn't decide on the best place for it.

Got a Hog3 and separate PC setup, Got a DP8000 when the s/w did away with the DP2000 but have come across a small issue,

We're trying to use it in art-net mode, all works fine, except the output was really erratic. Then i realised it was running in 75HZ mode, I've tried to re-flash it using v 3.1.9 which i believe is the last supported version, and within the PC software, the device reads as running at 25Hz but I can't change it, and the device sits in 75hz mode irrespective of what device (console or PC) it's connected to.

Any newer devices show the DP2k as "Incompatible software version" as I'd expect (3.2.0 and above)

Could anyone please offer some advice as to what i'm doing wrong? - I was hoping to still get use from this unit.

The unit receives art-net as expected, and spits out DMX, it's just at the wrong refresh rate I believe.

Many Thanks
Dean.
Parents
  • 0
    [QUOTE=marlon_at_sea;60364]can please anyone help me! i have the status ok on my dp2000 to use on LED but i dont know how to address the dmx for the LED. i dont see on DP2000. thank you so much!

    You are going to need to be a bit more specific as to what your actual issue is, and what your configuration is.
    Additionally, you would do well to start a new thread with a new topic rather than just tacking on to the end of an existing one.

    By "address the dmx for the LED" are you talking about patch?
    This will be done from the console, not the DP.
    There is plenty of info in the manual regarding patch.
    If not, then refer to the documentation for your particular LED fixture as this is not a DP/Console issue.

    If you need to configure your ArtNet Subnet and Universe, you can do this via the DP itself.
    The same goes for setting your ArtNet network IP and subnet.

    Hope this helps. :)
Reply
  • 0
    [QUOTE=marlon_at_sea;60364]can please anyone help me! i have the status ok on my dp2000 to use on LED but i dont know how to address the dmx for the LED. i dont see on DP2000. thank you so much!

    You are going to need to be a bit more specific as to what your actual issue is, and what your configuration is.
    Additionally, you would do well to start a new thread with a new topic rather than just tacking on to the end of an existing one.

    By "address the dmx for the LED" are you talking about patch?
    This will be done from the console, not the DP.
    There is plenty of info in the manual regarding patch.
    If not, then refer to the documentation for your particular LED fixture as this is not a DP/Console issue.

    If you need to configure your ArtNet Subnet and Universe, you can do this via the DP itself.
    The same goes for setting your ArtNet network IP and subnet.

    Hope this helps. :)
Children
No Data
Related

www.etcconnect.com