USB DMX Widget not installing

I have been using an old laptop (XP) to control my sanctuary lighting at the church using the HOG3PC software and a single USB DMX Widget. I have purchased a new mini desktop to place under our counter and have installed the software and moved the show over to the new PC. However I can not get the PC to successfully install the drivers for the USB DMX Widget. It shows the USB DMX Widget in the Device Manager, however it states there is no driver selected for the device information set or element. When I click on Update Driver, and search for the device, it states that it can not find driver software for your device.

Is there any location on your website that I can download the drivers to manually point to them and install them?

Thanks!!!

Jim Carter
Parents
  • 0
    Hello, from page 359 of the Hog 3 manual.

    To manually configure Widgets:
    1. Setup → Network : open the Network window.
    2. Select the DMX Processor 8000 in the list by clicking on its Network Number, and press the Settings button to open the DMX Processor Settings window.
    3. Select the Widget Outputs pane.
    4. The Hog 3PC application provides one port for each of the DMX outputs on
    the DMX Processor in the show file. To configure a widget to an output port
    of a DMX Processor, click on the box associated with the port and select the
    widget from the list of serial numbers that appears. Super Widget ports will
    appear with the serial number followed by an output number.
    5. Click Apply or OK to confirm the selection. The widgets that have been connected
    should now have their Active, DMX OK and TX Mode indicators illuminated.

    See Figure 30.2, “The Widget Outputs pane of the DMX Processor Settings
    window”

    www.flyingpig.com/support/hog3/documents/manual_en062911.pdf
Reply
  • 0
    Hello, from page 359 of the Hog 3 manual.

    To manually configure Widgets:
    1. Setup → Network : open the Network window.
    2. Select the DMX Processor 8000 in the list by clicking on its Network Number, and press the Settings button to open the DMX Processor Settings window.
    3. Select the Widget Outputs pane.
    4. The Hog 3PC application provides one port for each of the DMX outputs on
    the DMX Processor in the show file. To configure a widget to an output port
    of a DMX Processor, click on the box associated with the port and select the
    widget from the list of serial numbers that appears. Super Widget ports will
    appear with the serial number followed by an output number.
    5. Click Apply or OK to confirm the selection. The widgets that have been connected
    should now have their Active, DMX OK and TX Mode indicators illuminated.

    See Figure 30.2, “The Widget Outputs pane of the DMX Processor Settings
    window”

    www.flyingpig.com/support/hog3/documents/manual_en062911.pdf
Children
No Data
Related

www.etcconnect.com