I just purchased a programming wing and have patched a single volkslight 13 channel and there is no signal being recieved ? should I be using the pc software ? don't get it
The 3-pin is for the LED desklamp. Make sure that both the Programming Wing and the Widget are connected to your PC via USB cables.
Then Patch your fixtures. Open the Network status window by clicking the network icon to the right of the command line, and then select the internal DP-8000 and make sure your widget is mapped to the appropriate universe there. Plenty of info on this in the manual if you need specifics.
The 3-pin is for the LED desklamp. Make sure that both the Programming Wing and the Widget are connected to your PC via USB cables.
Then Patch your fixtures. Open the Network status window by clicking the network icon to the right of the command line, and then select the internal DP-8000 and make sure your widget is mapped to the appropriate universe there. Plenty of info on this in the manual if you need specifics.
