• State Not Answered
  • Date
    Reid36325
  • Date
  • Replies 23 replies
  • Subscribers 5 subscribers
  • Views 1616 views
  • Users 0 members are here

Sloooow Rollin'

My Road Hog recently decided to take ages to go to a cue. If anything on the console is above 0s, it makes twice the time to fade. Most of the cues I have are 3s because of the venue being a church. But occasionally I and a colleague use the console to program other (more exciting) shows. Loops that are 3 step loops at .2s a pice are 2 whole seconds between cues. Release times are about 12 seconds to release.
I updated the software Sunday to 3.2.5 and it did not do anything to help. Noting to my knowledge has changed. (Default times, etc.) The actual software is just sluggish. Even when I checked integrity it took it a good 6 seconds to process it.
So...What's up? (My inside says: WHATS WRONG WITH MY BABY??)

Thanks for the help.

(This may very well be operator error done by a volunteer that somehow got really deep down in a menu and screwed something up that I simply didn't think to check, though I doubt it.)
Parents
  • 0
    Alright. The saga continues. I replaced the cell battery and everything was great. Seemed like that was all it was. I ran through cues from 2 different shows, everything's great. Then I notice that in the full restore, my external monitor settings were messed up. So I restart the console. Boom, back to where we started. Yay.

    At the beginning of the boot up I get an error beep from the computer and different messages saying the CMOS settings are bad. So, apparently it is two of the 4.


    This thing is really sick...I may have to have honorary High End certification after this...haha.
Reply
  • 0
    Alright. The saga continues. I replaced the cell battery and everything was great. Seemed like that was all it was. I ran through cues from 2 different shows, everything's great. Then I notice that in the full restore, my external monitor settings were messed up. So I restart the console. Boom, back to where we started. Yay.

    At the beginning of the boot up I get an error beep from the computer and different messages saying the CMOS settings are bad. So, apparently it is two of the 4.


    This thing is really sick...I may have to have honorary High End certification after this...haha.
Children
No Data
Related

www.etcconnect.com