Wholehog 3 and Qlab Midi Timecode

Hi All,

I'm currently trying to run a Wholehog 3 off midi timecode. The current setup is A mac running Qlab which is running the shows audio. Which then plugs into a USB to Midi cable which then goes straight into the back of the Wholehog.

I can't get the hog to see the timecode? Is this setup possible? I can't seem to figure out what I'm doing wrong.

Cheers

Parents

0 yorchlights - Former HES Forum Member over 10 years ago

The midi section in the pannel control is only when you work with Hog3pc.

When you have the console you need.

Setup → Network: open the Network window. Select the console in the list. And press Settings: open the Settings window; “The MIDI pane of the Console Settings window”. In the MIDI pane, check MSC In or Out accord you need.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 yorchlights - Former HES Forum Member over 10 years ago

The midi section in the pannel control is only when you work with Hog3pc.

When you have the console you need.

Setup → Network: open the Network window. Select the console in the list. And press Settings: open the Settings window; “The MIDI pane of the Console Settings window”. In the MIDI pane, check MSC In or Out accord you need.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data