Wholehog 3 and Qlab Midi Timecode

Hi All,

I'm currently trying to run a Wholehog 3 off midi timecode. The current setup is A mac running Qlab which is running the shows audio. Which then plugs into a USB to Midi cable which then goes straight into the back of the Wholehog.

I can't get the hog to see the timecode? Is this setup possible? I can't seem to figure out what I'm doing wrong.

Cheers
Parents
  • 0
    Correct, I just said this additional

    All the rest of the settings are like said in the network section in the console tab.

    But for MTC you dont need MSC

    See also Section 28.4.1 and 28.5 of the HOG 3 manual
    www.highend.com/support/controllers/documents/H3_manual.pdf
Reply
  • 0
    Correct, I just said this additional

    All the rest of the settings are like said in the network section in the console tab.

    But for MTC you dont need MSC

    See also Section 28.4.1 and 28.5 of the HOG 3 manual
    www.highend.com/support/controllers/documents/H3_manual.pdf
Children
No Data

www.etcconnect.com