We have an ETC Smartfade 1224 (Might be a 1248 i get the models mixed up) with 24 Faders and 48 Channel Output. Lately The LCD Screen is stuck on set light with fader release to record. It Still outputs a DMX signal and the master and bumps seem to work as usual the board acts as if its stuck in recording a MEM but the buttons dont think it it is because the clear button isnt flashing and the mems Buttons arn't light up. when you press the menu button it opens the menu and changes whats on the LCD screen same for any other button that opens a menu however the default light channel display dosent show. any one else found this problem before. The Board is running the Firmware Version 2.0.1. We Have alot of important mems so resetting this really is a last resort.