Question about the York of D60

There's a quick adjustment you can make to work around this without replacing the yoke. Right now you have the c-clamp and yoke hanging straight down. If you loosen the clamp and rotate it around the pipe a little bit before tightening again, then the fixture can point straight down without interfering with the yoke.

Haha ~~

Do you mean like this? pipe and yoke with 80-75 degree? instead of 90 degree

By the way how about if we use the "SELD60FSY" D60 floor stand yoke combo
it looks like the stand yoke is longer than the original one

It's true that the main part of the floor stand yoke is about 2" longer than the standard yoke. If you remove the secondary floor-stand part, then you would have more clearance for the connectors and cables.

But yes, my suggestion was to hang the fixture so the yoke is at a 75-80 degree angle to the floor instead of the more normal 90 degree angle. That way the body of the fixture can still be at 90 degrees, but the connectors won't hit the yoke.

It's true that the main part of the floor stand yoke is about 2" longer than the standard yoke. If you remove the secondary floor-stand part, then you would have more clearance for the connectors and cables.

But yes, my suggestion was to hang the fixture so the yoke is at a 75-80 degree angle to the floor instead of the more normal 90 degree angle. That way the body of the fixture can still be at 90 degrees, but the connectors won't hit the yoke.