issues with arduino

So after I uploaded the box_1_src I am getting pings in the diagnostics section but with a different syntax this time. It now identifies the ping as box_1hello(s).

I have an i-pad running OSC on the system could that be an issue? I programmed the Arduino on my MAC and am trying it on my console (GIO@5). I am also getting the TX and RX blink during this as well.

0 sstaub over 6 years ago

Don't understand the problem, sending the pings is OK, it checks if the connection is ok, have a look to the source code line 576ff
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Brookstoran over 6 years ago in reply to sstaub

It indicates in the instructions that the continuous pings should end once box_1_src has been uploaded but i still get continuous pings as well as LX and RX still blinking in heart beat fashion. The arduino responds to pan and tilt being sent from the EOS device. I am wondering if this OK for operations or will the continuous pings be an issue.
I will look into line 576ff
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 sstaub over 6 years ago in reply to Brookstoran

Have a look to
github.com/.../50f8f61c7bd456f9c22a7363e120ba5819cd4904
There is a short explanation for the mechanism.
It has nothing to do with uploading a sketch to arduino.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel