Add fadres to a lighthackbox_2_v4.

Stefan Staub

Thank you very much for your help. I already have my new #lightBox working combining faders with encoders and buttons. It was a precious help. Thank's for your time

I just wanted to ask one more question. The fader reaches 100% before reaching the top.
Is this a problem in the code or did I make a bad call?

Stefan Staub

Thank you very much for your help. I already have my new #lightBox working combining faders with encoders and buttons. It was a precious help. Thank's for your time

I just wanted to ask one more question. The fader reaches 100% before reaching the top.
Is this a problem in the code or did I make a bad call?

When it is short before the top, it is by the code. It is also when you are at 0%, you must move the fader a little bit before it reacts. It is necessary because of the jitter in the analog inputs, you can control it with #define THRESHOLD 

What happens is the opposite. The fader is still in the middle and says it is already at 100%. So this is an error in the connections?

This sounds more like a 0-100 vs 0-255 issue?

It is the connection, there was error in the description, the leveler pin is most at the outer position. Swapping the GND and leveler pin should solve the problem.

Here a photo of a fader:

Don't forget a 10nF ceramic capacitor (code 103) between ground and leveler for preventing analog noise.

I tried to do that but what happened was to change the direction of the fader.
what happens is that my fader has a 7cm path and after 4cm it is already full

Is it a linear fader?

yes. its a 10kR 200mW mono metallic linear sliding potentiometer

Problem solved!!!
The power was at 6V and I had to switch to 3.3V and everything was resolved.
Thanks again for the help you provided me.