ETC Labs

#lighthack Usb osc

State Not Answered
Date Yan G
Date Sun, Feb 20 2022 10:55 AM
Replies 4 replies
Subscribers 65 subscribers
Views 3386 views
Users 0 members are here

Options

Related

Usb osc

Hello,

I have a USB OSC buttons panel (based on light hack) that works well with 3.0.2, but not with 3.1 freshly installed.

I'm using a Mac under 10.14 Mojave, I try to activate/desactivate OSC fields in setup but nothing helps.

Any Ideas?

Thanks

Parents

0 sstaub over 2 years ago

Which microcontroller did you use? What said the diagnostic tab?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Yan G over 2 years ago in reply to sstaub

Hello Sstaub, sorry for my late reply, I use a ESP32, and the diagnostic tab only says:

OSC USB Device Handshake initiated [ETCOSC?] and nothing more.

Whats I don't understand is this setup works well with 3.0.2 and not with 3.1

Thanks
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 sstaub over 2 years ago in reply to Yan G

Maybe you must update your Mac for proper use with v3.1.x. I can remember there was a post about.
It can also a driver problem of the ESP32 module.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 sstaub over 2 years ago in reply to Yan G

You must delete following lines or similar in setup() of the code

#ifdef BOARD_HAS_USB_SERIAL

while (!SerialUSB);

#else

while (!Serial);

#endif

The while loop does only work on classic AVRs like UNO/MEGA
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 sstaub over 2 years ago in reply to Yan G

You must delete following lines or similar in setup() of the code

#ifdef BOARD_HAS_USB_SERIAL

while (!SerialUSB);

#else

while (!Serial);

#endif

The while loop does only work on classic AVRs like UNO/MEGA
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data

Top