Hi, we just finished an installation in a community center where we installed 31 Pro One-Cell Small and 55 Arclamps. The F-Drive is equipped with 8 cc150 cards and 3 Arclamp-150 cards. This gear acts as the main lights for the auditorium, when anybody enters the room and hits the switch the light turns on. So the F-drive has to stay on all the time. Even with no load (lights off, which means about 90% of the time) the fans are running on full speed and are very noisy. (I`m not talking about the meanwell psu units whitch we replaced because of they`re terrible noise). The question is: is there any way to get the fans temperature or load controlled?
At this time we do not have temp or load controlled fan speed. We will keep this in mind as we continue development of the F-drive system.